Best way to hook up line output converter
Find More Posts by Erick Sermon.
You could grab your audio signal right at the stock subwoofer in the Cadillac. The LOC is your input signal.
So be best lesbian dating application you get your signal from the stock subwoofer if your vehicle comes equipped with one. If you were testing all of your wires earlier with a multimeter, you should know which wire is a switched power source. I was thinking of replacing them with Polk Audio components in the front and coaxial for the back.
So, I have a Toyota 4Runner. You can read more about the new JL Audio processor herescroll towards the bottom of the post.
Hi Brandyn, Probably running too low an impedance to the amp, this is the most common issue I see. BB code is On. I did it all with a little hard work and wal mart.
Once you find the speaker wires, use the wire strippers to remove 1 inch of insulation from each one. Attach the left channel of the L. There is also no remote wire in the harness, how does my am know when to turn on?
The best way to do this would be to use a processor that corrects the audio coming out of the head unit before it gets fed into the amp. Hi i just bought a Lincoln mkz. Switched back the RCA cables and it stops and returns to normal.
To make your speaker wire tester, simply take some speaker wire and electrical tape the positive wire to the positive post and the negative wire to the negative end of the battery.
Tap into the wires for the pre-amp signal, in the harness to the amp. Line Output Converters Line output converters LOCs are used to convert a head unit's speaker outputs or the outputs of an OEM amplifier into a signal suitable to drive the preamp inputs of an amplifier.
Car Audio Defined By A Chick
Hi Matt, Sorry I could not reply sooner — interesting story there. Doesn't sound like you've got the right wires.
Line output convertor LP has adjustable input signals and signal sensing remote turn on. With Audison I had many defective units and it would take months, even over a year in one occasion, to have them repaired or exchanged one of the reasons we stopped carrying them. The following image shows what the inside of a basic line output converter looks like.