Fuel gauge hook up Fuel gauge hook up

Fuel gauge hook up

Brandy Alexander began writing professionally in Turn the key to the "On" position and cycle the dashboard lights on and off while checking to find the corresponding fuse.

Best time to hook up in vegas

Twist these two wires together and cover them with a layer of electrical tape. Open the fuse panel and touch the tip of the test lamp to the exposed metal side of the fuses until the light comes on in the test lamp.

Facilitate this by tightening the exposed tip of the wire under a bolt that screws into a metal surface on the vehicle. Installing an Auto Meter fuel gauge is an easy task once you have decided how and where to mount it. About the Author Brandy Alexander began writing professionally in Connect the "S" wire to the fuel-sender signal wire you removed from the stock fuel gauge.

You can even use your stock fuel-level sender cable, so you will only need to connect four wires for your new gauge to begin working.

Turn the ignition key to the "On" position. She has years of experience as a professional of the English language employed with the "Cape Times" and "The Mercury. This wire is fed directly to the fuel gauge hook up on the fuel-level sender in the fuel tank. If you do not fuel gauge hook up a space in the dashboard or do not want to cut holes in it, purchase a bracket that will mount the gauge on top of or under the dashboard.

On nearly all vehicles, the metal chassis is also the ground negativeallowing you to complete a circuit by touching any metal surface. Adding any Auto Meter gauge to your vehicle will help to ensure accurate and consistent readings from your car or truck.

Dating a girl who had been raped

Use your test lamp to determine the fuse for the dashboard instrument lights. Select an appropriate mounting location for your new gauge.

Wrap any exposed wire with a layer of electrical tape to prevent shorts. Over the years, Auto Meter has established itself as a manufacturer of quality, professional automotive gauges. Identify and isolate the four wires protruding from the back of the gauge pod. Items you will need Wire cutters 12 volt test lamp Screw drivers Electrical tape.

When found, your test lamp will light up with the dash lights. Clamp the alligator clamp of the test lamp to a bare-metal surface on the car.

Christmas gift ideas for dating

Connect the end of the "-" wire to a bare-metal surface on the vehicle.