Hook up waterline to refrigerator
She writes mainly home improvement, health and travel articles for various online publications.
She has several years of experience in the home-improvement industry, focusing on gardening, and a background in group exercise instruction. This DIY "Do it Yourself" website was created by maintenance professionals and home renovating experts.
A refrigerator with an automated ice maker and a built-in water dispenser does absolutely nothing if you do not have a water line to connect to it. If you have a water dispenser on your fridge, dispense about a gallon of water and spill it down the kitchen sink drain.
Do not tighten the clamps with excessive force as you can actually distort the copper piping. The valve connected to the right side of the faucet is the cold water supply line.
Copy and paste this code: Harsch received her Certified Nurses Assistant license in About the Author Cecilia Harsch has been writing professionally since Step 6 — Get out the plastic water tubing from your fridge water line kit. If you need help replacing the filter, here is a guide to replace a refrigerator water filter. Thread the water line, included in the ice maker installation kit, from the area behind the refrigerator to beneath the sink.
Twist the faucet supply line onto the female end of the adapter. Leave this field empty. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line.
Run the water line into the bucket until the water is perfectly clean and clear. Step 8 — Now your hook up waterline to refrigerator water tube should be connected to the cold water valve you just installed.
Keep an extra 8 to 10 feet of water tubing rolled up neatly behind the refrigerator to allow enough tubing to be pulled out if you have to slide the refrigerator away from the wall. Drill holes in the base cabinet walls to route the water line from beneath the sink to the rear of the refrigerator.
Step 2 — You will be drilling a hole into the cold water pipe so turn off the main water supply to your complete house. You may have to drill a hole through the wall or the floor if needed to get the other end to the water valve.
Wrap threads on the cold water valve with two or three wraps of thread-seal tape. Push the refrigerator against the wall. You may have a cold water pipe either behind the wall where the fridge is or possibly in the floor under the kitchen. References 4 The Family Handyman: Slip the compression nut that came with the kit over the newly installed supply line.
- Harry styles dating past
- Junior in college dating junior in high school
- 1 night stand dating website
- Jewish and african american dating
- Best texas dating sites
- Blog 40 days of dating
- Providence ri speed dating
- Online dating wordpress theme
- Advice for dating someone with aspergers
- What does christian dating look like